CAUTION: Before carrying out any adjustment or service work, always disengage all drives, shut off engine and wait until all moving parts have stopped.

IMPORTANT: Most metal detector malfunctions result from poor connections or broken wires. Always check connections and wiring before replacing components.

IMPORTANT: The following troubleshooting charts must be followed by sequence. Once

a problem is determined and corrected, go back to "Metal Detector Test" to ensure proper system operation.

IMPORTANT: When carrying out repairs in the feed roll area, do not weld moving or rotating parts.

Always use genuine John Deere parts, since these parts have been demagnetized.

ZX,OMSPFH001193 -19-01OCT91-1/1