|
Display is blank
|
No power
|
Check harness connections at the display.
|
|
|
Out of contrast or insufficient backlighting
|
Adjust the contrast. Change backlighting level intensity.
|
|
Display audible alarm does not sound
|
Possible failed alarm
|
See your John Deere dealer.
|
|
Display is locked up on a certain page
|
Communication problem
|
Turn ignition key OFF and ON.
|
|
RUN pages are not fully displayed
|
Connection between display and job computer is defective
|
Check wiring harness connections. See your John Deere dealer.
|
|
|
Standard layout is not effective
|
Configure Run Page Layout.
|
|
|
Job computer is defective
|
See your John Deere dealer.
|
|
Only RUN and PAGE are displayed on top of RUN pages
|
Display address is not set to PRIMARY
|
Select PRIMARY display address.
|
|
|
After PRIMARY display address has been chosen, display shows only horizontal lines
|
Press on key RUN or PAGE.
|
|
Day backlight is too dark or night backlight is too bright
|
Day or night backlight not adjusted correctly
|
Adjust day and night backlight accordingly.
|
|
Engine hours are not displayed
|
Signal problem
|
See your John Deere dealer.
|