| Trouble Code |
Key Word Strings |
Text Strings |
Description/Reason |
Comments |
| 201 |
Feed roll speed too high |
Feed roll speed exceeded maximum alarm value. |
Feed roll speed exceeded the user defined value while speed alarm is activated in setup. |
Check LOC or decrease feed roll speed |
| 202 |
Feed roll speed too low |
Feed roll speed fell below minimum alarm value. |
Feed roll speed fell below the user defined value while speed alarm is activated in setup. |
Check LOC or increase feed roll speed |
| 203 |
Feed roll height too high |
Feed roll height exceeded maximum alarm value. |
Feed roll height exceeded the user defined value while height alarm is activated in setup. |
Decrease Ground Speed to decrease feed roll height |
| 204 |
Feed roll height too low |
Feed roll height fell below minimum alarm value. |
Feed roll height fell below the user defined value while height alarm is activated in setup. |
Increase Ground Speed to increase feed roll height |
| 205 |
% level too high |
Moisture level exceeded maximum alarm value. |
Actual measured moisture exceeded the user defined value while moisture alarm is activated in setup. |
Check your moisture calibration or wait until the forage is dry enough |
| 206 |
% level too low |
Moisture level fell below minimum alarm value. |
Actual measured moisture fell below the user defined value while moisture alarm is activated in setup. |
Check your moisture calibration |
| 207 |
Com. problems |
Communication problems. |
SPFH Yield controller has detected a CAN-bus problem. |
Contact your dealer |
| 208 |
Job computer error |
There is an error in the job computer. |
Job computer is defective. |
Contact your dealer |
| 209 |
Feeroll height sensor error |
There is an error in the feed roll height sensor. |
Feed roll sensor or cable to the sensor is defective. |
Contact your dealer |
| 210 |
% sensor error |
There is an error in the moisture sensor. |
Moisture Sensor or cable to the sensor is defective. |
Contact your dealer |
| 211 |
Display version |
Wrong display version. |
Display version is too low. |
Get the minimum required Display version from your dealer. Otherwise there is no guarantee for proper operation! |
| 212 |
CH speed error |
There is an error in the cutterhead speed sensor. |
Cutterhead speed sensor or cable to the sensor is defective. |
Contact your dealer |
| 213 |
Feed roll speed sensor error |
There is an error in the feed roll speed sensor. |
The feed roll speed sensor or the cable to the sensor is defective. Or the distance between the sensor and the sender is not in a range between 5 mm and 11 mm or sensor and sender are loose. |
Check the distance between sensor and sender. Check if sensor and sender are loose. Check the cables. |
| 214 |
Vehicl. speed sensor error |
There is an error in the vehicle speed sensor. |
Vehicle speed sensor or cable to the sensor is defective. |
Contact your dealer |