| Trouble Code |
Problem |
Description/Reason |
Comments |
| 20 |
Implement disconnected. |
A previously logged on implement has been disconnected from the CAN bus. |
Check all component connectors for proper engagement. |
| 21 |
Display conflict. |
An implement has attempted to write to a run page display section it has not previously been allocated. |
Make a Run Page Layout |
| 30 |
Too many devices on CAN bus. |
Attempted to logon more than 8 implements to the CAN bus. |
Disconnect unnecessary implements. |
| 31 |
Display overload. |
Display keys pushed too rapidly. |
Cycle power. |
| 33 |
Memory failure. |
Internal problem with display. |
Cycle power. If trouble code 33 appears again then replace display. |
| 110 |
CAN bus problem. |
Communication problem with CAN bus. |
Check CAN bus wiring harness and terminators. Contact your dealer. |
| 111 |
CCD bus problem. |
CCD bus hardware/wiring errors. |
Check CCD wiring between digital tach and display. Contact your dealer |
| 112 |
Display conflict Run Page Layout. |
Two or more devices are requesting the same screen allocation. |
Make a Run Page Layout |