Changing Engine Crankcase Filter Element

Proceed as follows:

1. Remove filter element (A) and clean mounting surface.

2. Apply a thin film of oil to sealing ring of new filter.

3. Tighten new filter element until sealing ring touches mounting surface and then turn an additional 3/4 to 1-1/4 turns. Do not overtighten!

4. Start engine and check base of filter for leaks.

5. Shut off engine and check oil level.

NOTE: Carry out first oil filter change after first 100 hours of operation.

OUZXMAG,00010AE -19-26JUN01-1/1