Introduction
Product Identification
Safety
Operating Machine
Operating Cutting Units
Replacement Parts
Service Interval Chart
Service Lubrication
Grease Locations: Lubricate Daily
Grease Locations - Lubricate Weekly
Service Engine
Service Transmission
Service Cutting Units
Service Electrical
Service Miscellaneous
Troubleshooting
Storage
Assembly
Specifications
Warranty
John Deere Quality Statement
Service Record
CopyrightŠ Deere & Company
Service Lubrication
Grease
Use grease based on the expected air temperature range during the service interval.
The following greases are preferred:
ˇ John Deere MOLY HIGH TEMPERATURE EP GREASE
ˇ John Deere HIGH TEMPERATURE EP GREASE
Other greases may be used if they meet one of the following:
ˇ SAE Multipurpose EP Grease with a maximum of 5% molybdenum disulfide.
Greases meeting Military Specification MIL-G-10924F may be used as arctic grease.
Grease Locations: Lubricate Daily
IMPORTANT: Avoid damage! Lubricate immediately after washing the machine to remove water before bearings cool and "suck in" water and contaminates. |
A - Lift Cylinder End - 6 places
C - Lift Arms and Pivots - 3 places
D - Rear Rollers (both ends) - 10 places
E - RFS Spring (22 ESP) - 5 places
A - Rear Roller Bearings (both ends) - 10 places
B - Front Rollers (both ends) - 10 places
Grease Locations - Lubricate Weekly
A - Follower Bearing (3215B/3225B)
A - Eccentric on Neutral Start Linkage (3215B/3225B)
Greasing Rear Lift Linkage
NOTE: At 200 hours or during scheduled engine oil change, a new layer of grease needs to be applied under the washers and to the short straps where they are exposed through the slot holes in the long strap.
Grease lift arm (through rear of lift arms) and front cast pivots. Grease both ends of the lift linkage at locations (A).