OMLVU11184

Issue E0

Compact Utility Tractors

4500

PIN (150001 - )

4600

PIN (160001 - )

4700 (Gear)

PIN (190001 - )

4700 (Hydro)

PIN (175001 - )

Introduction

Product Identification

Safety

Operating

Replacement Parts

Service Intervals

Service Lubrication

Service Engine

Service Transmission

Service Electrical

Service Miscellaneous

Troubleshooting

Storage

Storing Safety

Preparing Tractor for Storage

Removing Tractor From Storage

Assembly

Specifications

Warranty

John Deere Quality Statement

Service Record

Storage

Storing Safety

c CAUTION: Avoid injury! Fuel vapors are explosive and flammable. Engine exhaust fumes contain carbon monoxide and can cause serious illness or death: · Run the engine only long enough to move the machine to or from storage. · Do not store vehicle with fuel in the tank inside a building where fumes may reach an open flame or spark. · Allow the engine to cool before storing the machine in any enclosure.

Preparing Tractor for Storage

1. Service the air cleaner.

2. Change engine oil and filter if needed.

3. Repair worn or damaged parts. Install new parts if necessary.

4. Wash tractor. Clean engine and engine area.

5. Drain fuel and add back 4 L (1 gal) of fuel. Then add 0.4 L (12 oz.) of stabilizer/corrosion inhibitor.

6. Add 0.25 L (9 oz.) of corrosion inhibitor to transmission/hydraulic system.

7. Start engine and run until it reaches operating temperature.

8. Add 0.5 L (16 oz.) more storage inhibitor to the fuel tank.

9. Add 0.5 L (16 oz.) storage inhibitor to the engine crankcase at the air filter/breather.

10. Loosen alternator/fan belt.

11. Remove and clean battery. Store in a cool dry place. Do not allow battery to freeze. Keep it charged.

MIF

12. Gear Models: Depress clutch pedal (A) completely. Insert a block of wood (B) between the top of the clutch pedal arm and bottom of foot platform (C) as shown.

13. Lubricate grease points.

14. Apply multi-purpose grease on exposed hydraulic cylinder rods.

15. Move hydraulic levers back and forth to release pressure.

16. Put blocks or stands under tractor to take weight off tires. Let 1/3 of air out of tires.

17. Apply paint to areas that need it to prevent rust.

18. Store the vehicle in a dry, protected place. If unit is stored outside, put a waterproof cover over it.

Removing Tractor From Storage

1. Remove blocks and supports from under tractor.

2. Gear Models: Remove wood block between clutch pedal arm and foot platform.

3. Check tire pressure.

4. Check engine oil level.

5. Check transmission oil level.

6. Check front axle oil level.

7. Check battery electrolyte level. Charge battery if necessary.

8. Install battery.

9. Install alternator/fan belt if removed.

10. Lubricate all grease points.

11. Open fuel shut-off valve.

12. Run the engine 5 minutes to allow oil to be distributed throughout engine.

13. Be sure all safety equipment is in place.