John Deere

OMM139226

Issue A9

Compact Utility Tractor with Gear Transmission

790 Serial No. (190064 - )

Introduction

Safety Signs

Controls

Operating

Replacement Parts

Service Machine Safely

Service Intervals

Service Engine

Service Transmission

Service Electrical

Service Miscellaneous

Troubleshooting

Storing Machine

Storing Safely

Storing Machine

Removing Machine From Storage

Assembly

Specifications

Warranty

John Deere Service Literature

John Deere Quality Statement

All Manuals Close Window

Storing Machine


Storing Safely


MIF

c CAUTION: Avoid injury! Engine exhaust fumes can cause sickness or death.

- If it is necessary to run an engine in an enclosed area, use an exhaust pipe extension to remove the fumes.

- Always try to work in a well ventilated area.

- Do not store machine with fuel in tank in a building where fumes may reach an open flame or spark.

- Allow engine to cool before storing in ay enclosure.

- Remove the battery and store it in a cool dry place where it will not freeze, and where children cannot reach it.

Storing Machine

IMPORTANT: Avoid damage! Follow storage procedure anytime tractor will not be used for several months to minimize corrosion and deterioration.


1. Service air cleaner. (See Servicing Air Cleaner in service section.)

2. Change engine oil and filter if needed.

3. Repair worn or damaged parts. Install new parts if necessary.

4. Wash tractor. Clean engine and engine area.

5. Drain fuel and add back 4 L. (1 gal.) of fuel. Then add 0.4 L (12 oz.) of stabilizer/corrosion inhibitor.

6. Add 0.25 L (9 oz.) of corrosion inhibitor to transmission-hydraulic system.

7. Start engine and run until it reaches operating temperature.

8. Add 0.5 L (16 oz.) more storage inhibitor to the fuel tank.

9. Add 0.5 L (16 oz.) storage inhibitor to the engine crankcase at the air filter/breather.

10. Loosen alternator/fan belt after it has cooled.

11. Remove and clean battery. Store in a cool dry place. DO NOT allow battery to freeze. Keep it charged.

12. Lock clutch pedal (A) in the disengaged position with the clip (B) provided.


M97749

13. Lubricate grease points.

14. Apply multi-purpose grease on exposed hydraulic cylinder rods.

15. Move hydraulic levers back and forth to release pressure.

16. Put blocks or stands under tractor to take weight off tires. Let 1/3 of air out of tires.

17. Apply paint to areas that need it to prevent rust.

18. Store the vehicle in a dry, protected place. If unit is stored outside, put a waterproof cover over it.

Removing Machine From Storage

1. Check tire pressure and fill tires with air. (See Checking Tire Pressure in Service Miscellaneous section.)

2. Remove grease from cylinder rods.

3. Install alternator/fan belt if removed before storage.

4. Remove blocks and supports from under tractor.

5. Fill fuel tank. Open fuel shut-off valve.

6. Check battery electrolyte level. Charge battery if necessary. Install battery.

7. Lubricate all grease points.

8. Check transmission and engine oil levels.

c CAUTION: Avoid injury! Start engine ONLY in a well-ventilated area.

9. Run the engine 5 minutes with no engine load.

10. Be sure all shields and guards are in place.