Safety

On your machine safety labels, the words DANGER, WARNING, and CAUTION are used with this safety-alert symbol. DANGER identifies the most serious hazards.

The operator's manual also explains any potential safety hazards whenever necessary in special safety messages that are identified with the word, CAUTION, and the safety-alert symbol.

WARNING: AVOID SERIOUS INJURY OR DEATH

M47707a MX11148

· Drive up and down slopes, not across.

· Avoid sudden turns.

· If machine stops going uphill, stop blade and back down slowly.

· Keep safety devices (guards, shields, and switches) in place and working.

· Read Operator's Manual.

· When leaving machine: Stop engine, Set park brake, Remove key.

DANGER: ROTATING BLADES CUT OFF ARMS AND LEGS

M47707b MX11148

· Do not mow when children or others are around.

· Do not mow in reverse.

· Look down and behind before and while backing.

· Never carry children even with the blades off.

WARNING: LOADED SPRING (For Optional Lift Assist Kit)

M88494 MX11148

Picture Note: Label is located on left-hand side of mower deck when optional lift assist kit is installed

· To avoid injury from loaded spring, read Operator's Manual before changing attachment.

DANGER: SHIELD EYES-EXPLOSIVE GASES CAN CAUSE BLINDNESS OR INJURY

M88490 MX11148

Picture Note: Label is located on battery

· No sparks, flames, smoking.

· Sulfuric acid can cause blindness or severe burns.

CAUTION: Flush Eyes Immediately With Water

· Get medical help fast.

· Keep out of reach of children.

· Do not tip.

· Keep vent caps tight and level.

DANGER: ROTATING BLADE

M38614 MX11148

Picture Note: 38-inch deck used for illustration. Decals are located on: left-hand side of all decks (and) right-hand side of Freedom42 deck

· Do not put hands or feet under or into mower when engine is running.

DANGER: ROTATING BLADE

M38613 MX11148

Picture Note: Labels are located on discharge chute and right-hand side of 38-inch deck

· Do not put hands or feet under or into mower when engine is running.

Thrown Objects

· Before mowing, clear area of objects that may be thrown by blade.

· Do not operate mower without discharge chute or entire grass catcher in place.

Emission Control System Certification Label

NOTE: Tampering with emission controls and components by unauthorized personnel may result in severe fines or penalties. Emission controls and components can only be adjusted by EPA and/or CARB authorized service centers. Contact your John Deere Commercial and Consumer Equipment Retailer concerning emission controls and component questions.

The presence of an emissions label signifies that the engine has been certified with the United States Environmental Protection Agency (EPA) and/or California Air Resources Board (CARB).

The emissions warranty applies only to those engines marketed by John Deere that have been certified by the EPA and/or CARB; and used in the United States and Canada in off-road mobile equipment.

Emission Compliance Period

If your engine has the emission compliance category listed on the emission control system certification or air index label, this indicates the number of operating hours for which the engine has been certified to meet EPA and/or CARB emission requirements. The following table provides the engine compliance period in hours associated with the category found on the certification label.


Agency	Category	Hours
EPA	C	250
EPA	B	500
EPA	A	1000
CARB	Moderate	125
CARB	Intermediate	250
CARB	Extended	500

Certification

Your mower has been certified by an independent laboratory for compliance with American National Standard B-71.1, "Safety Specifications" for Power Lawn Mowers, Lawn and Garden Tractors, and Lawn Tractors.

Operating Safely

MIF

· Read, understand and follow all instructions in the manual, on the machine and on the safety video before starting.

· Only allow responsible adults, who are familiar with the instructions to operate the machine.

· Inspect machine before you operate. Be sure hardware is tight. Repair or replace damaged, badly worn, or missing parts. Be sure guards and shields are in good condition and fastened in place. Make any necessary adjustments before you operate.

· Do not operate mower without discharge chute or entire grass catcher in place.

· Check brake action before you operate. Adjust or service brakes as necessary.

· Stop machine if anyone enters the area.

· If you hit an object, stop the machine and inspect it. Make repairs before you operate. Keep machine and attachments properly maintained and in good working order.

· Be aware of the mower discharge direction and make sure that no one is in the path of the discharge direction.

· Do not leave machine unattended when it is running.

· Only operate during daylight or with good artificial light.

· Be careful of traffic when operating near or crossing roadways.

· Do not wear radio or music headphones while operating the machine. Safe operation requires your full attention.

· Older adults are involved in a large percentage of riding mower accidents involving injury. These operators should evaluate their ability to operate a mower safely enough to protect the operator and others from serious injury.

Checking Mowing Area

· Clear mowing area of objects that might be thrown. Keep people and pets out of mowing area.

· Study mowing area. Set up a safe mowing pattern. Do not mow where traction or stability is doubtful.

· Test drive area with mower lowered but not running. Slow down when you travel over rough ground.

Parking Safely

1. Stop machine on a level surface, not on a slope.

2. Disengage mower blades.

3. Lower attachments to the ground.

4. Lock the park brake.

5. Stop the engine.

6. Remove the key.

7. Wait for engine and all moving parts to stop before you leave the operator's seat.

Rotating Blades are Dangerous

HELP PREVENT SERIOUS OR FATAL ACCIDENTS:

· Rotating blades can cut off arms and legs, and throw objects. Failure to observe safety instructions could result in serious injury or death.

· Keep hands, feet and clothing away from mower deck when engine is running.

· Be alert at all times, drive forward carefully. People, especially children can move quickly into the mowing area before you know it.

· Before backing up, stop mower blades or attachments and look down and behind the machine carefully, especially for children.

· Do not mow in reverse.

· Shut off blades when you are not mowing.

· Do not operate machine if you are under the influence of drugs or alcohol.

· Park machine safely before inspecting, removing, or unplugging mower or bagger.

PROTECT CHILDREN:

· Tragic accidents can occur if the operator is not alert to the presence of children. Keep children out of the mowing area and under the watchful care of another responsible adult.

· Never assume that children will remain where you last saw them. Children are attracted to mowing activity, stay alert to the presence of children.

· Keep children indoors when you are mowing. Turn the machine off if a child enters the mowing area.

· Use extra care when you come to blind corners, shrubs, trees, or other objects that may block your vision.

· Do not let children or an untrained person operate the machine.

· Do not carry or let children ride on any attachment or machine even with the blades off. Do not tow children in a cart or trailer.

Avoid Tipping

· Slopes are a major factor related to loss-of-control and tip-over accidents, which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it.

· Keep all movement on slopes slow and gradual. Do not make sudden changes in speed or direction.

· Slow down before you make a sharp turn or operate on a slope. Choose a low gear or speed so that you will not have to stop or shift while on the slope.

· Do not turn on slopes unless necessary. Turn slowly and turn downhill. Do not shift to neutral and coast downhill.

· Stay alert for holes and other hidden hazards in the terrain. Uneven terrain could overturn the machine. Tall grass can hide obstacles.

· Keep away from drop-offs, ditches and embankments.

· Use extra care with grass catchers or other attachments. These can change the stability of the machine. Do not use grass catcher on steep slopes.

· Use recommended weights for added stability when operating on slopes or using front or rear mounted attachments. Remove weights when not required.

· Drive up and down a hill - not across.

· Do not stop when going up hill or down hill. If machine stops going up hill, disengage mower blades and back down slowly.

· Mowing when grass is wet can cause reduced traction and sliding.

· Do not try to stabilize the machine by putting your foot on the ground.

Keep Riders Off

MIF

· Only allow the operator on the machine. Keep riders off.

· Riders on the machine or attachment may be struck by foreign objects or thrown off the machine causing serious injury.

· Riders obstruct the operator's view resulting in the machine being operated in an unsafe manner.

Wear Appropriate Clothing

· Wear close fitting clothing and safety equipment appropriate for the job.

· Always wear safety goggles or safety glasses with side shields when operating the mower.

· Wear a suitable protective device such as earplugs. Loud noise can cause impairment or loss of hearing.

· Do not wear radio or music headphones. Safe service and operation requires your full attention.

Driving Safely on Public Roads


Avoid personal injury or death resulting from a collision with another vehicle on public roads: · Use safety lights and devices. Slow moving machines when driven on public roads are hard to see, especially at night. · Whenever driving on public roads, use flashing warning lights and turn signals according to local regulations. Extra flashing warning lights may need to be installed.

Practice Safe Maintenance

· Understand service procedure before doing work. Keep area clean and dry.

· Never lubricate, service, or adjust machine while it is moving. Keep safety devices in place and in working condition. Keep hardware tight.

· Keep hands, feet, clothing, jewelry, and long hair away from any moving parts, to prevent them from getting caught.

· Lower attachments to the ground before servicing machine. Disengage all power and stop the engine. Lock park brake and remove the key. Let machine cool.

· Disconnect battery or remove spark plug wire before making any repairs.

· Keep all nuts and bolts tightened, especially blade attachment bolts.

· Securely support any machine elements that must be raised for service work.

· Never run engine unless park brake is locked.

· Keep all parts in good condition and properly installed. Fix damage immediately. Replace worn or broken parts. Replace all worn or damaged safety and instruction decals.

· To prevent fires, remove any buildup of grease, oil, or debris from the machine, especially the engine compartment.

· Charge battery in an open, well-ventilated area, away from sparks. Unplug battery charger before connecting or disconnecting from the battery. Use insulated tools.

· Do not modify machine or safety devices. Unauthorized modifications may impair its function and safety.

· Do not wear radio or music headphones while servicing the machine. Safe service requires your full attention.

Tire Safety

Explosive separation of a tire and rim parts can cause serious injury or death:

· Do not attempt to mount a tire without the proper equipment and experience to perform the job.

· Always maintain the correct tire pressure. Do not inflate the tires above the recommended pressure. Never weld or heat a wheel and tire assembly. The heat can cause an increase in air pressure resulting in a tire explosion. Welding can structurally weaken or deform the wheel.

· When inflating tires, use a clip-on chuck and extension hose long enough to allow you to stand to one side and NOT in front of or over the tire assembly.

· Check tires for low pressure, cuts, bubbles, damaged rims or missing lug bolts and nuts.

Handling Fuel Safely

Fuel and fuel vapors are highly flammable:

· Do not refuel machine while you smoke, when machine is near an open flame or sparks, or when engine is running. stop engine and allow to cool before filling.

· Never remove the fuel cap or add fuel with the engine running.

· Never fill fuel tank or drain fuel from a machine in an enclosed area. Fill fuel tank outdoors.

· Prevent fires. Clean up spilled fuel immediately.

· Do not store machine with fuel in tank in a building where fumes may reach an open flame or spark.

· Prevent fire and explosion caused by static electric discharge. Use only non-metal, portable fuel containers approved by the Underwriter's Laboratory (U.L.) or the American Society for Testing & Materials (ASTM). If using a funnel, make sure it is plastic and has no screen or filter.

· Static electric discharge can ignite gasoline vapors in an ungrounded fuel container. Remove the fuel container from the bed of a vehicle or the trunk of a car and place on the ground away from the vehicle before filling. Keep nozzle in contact with container opening while filling.

· When practical, remove equipment from trailers or truck beds and refuel them on the ground. If this is not possible, use a portable, plastic fuel container to refuel equipment on a truck bed or trailer.

· For gasoline engines, do not use gas with methanol. Methanol is harmful to your health and to the environment.

Handling Waste Product and Chemicals

Waste products, such as, used oil, fuel, coolant, brake fluid, and batteries, can harm the environment and people:

· Do not use beverage containers for waste fluids - someone may drink from them.

· See your local Recycling Center or John Deere dealer to learn how to recycle or get rid of waste products.

· A Material Safety Data Sheet (MSDS) provides specific details on chemical products: physical and health hazards, safety procedures, and emergency response techniques. The seller of the chemical products used with your machine is responsible for providing the MSDS for that product.

About Our Site | Privacy | Legal