Service Intervals


IMPORTANT: Avoid damage! Operating in extreme conditions may require more frequent service intervals: · Engine components may become dirty or plugged when operating in extreme heat, dust or other severe conditions. · Engine oil may lose efficiency if vehicle is operated constantly at slow or low engine speeds or with frequent short trips.

Please use the following timetables to perform routine maintenance on your machine.

· Check engine oil level.

· Check tire pressure.

· Tighten all hardware.

· Check wheel lug nut torque 237 N·m (175 lb-ft).

· Check alternator belt tension.

· Change hydraulic oil filter.

· Check engine oil level.

· Check hydraulic system oil level.

· Clean radiator and oil cooler from trash build up.

· Check coolant level.

· Drain water and sediment from fuel filter.

· Check alternator belt tension.

· Lubricate boom linkage and cylinder pivot points.

· Lubricate Quik-Tatch mounting plate latches.

· Check tire pressure.

· Change engine oil and filter.

· Check wheel lug nut torque 237 N·m (175 lb-ft).

· Change engine oil and filter. (When using John Deere filter and Plus 50 oil interval is 300 hours.)

· Tighten cab hardware.

· Replace both in-line fuel filter and fuel water separator filter.

· Replace primary air cleaner element.

· Check chain case oil level.

· Check/clean oil reservoir breather.

· Change hydraulic oil filter.

· Replace secondary air cleaner element.

· Change chain case oil.

· Replace in-line hydrostatic case drain filters (single speed skid steers only).

· Change hydraulic oil.

· Tighten all hardware.

· Flush cooling system.