Service Interval Chart


AFTER FIRST 2 HOURS OF OPERATION	Change engine oil.
AFTER FIRST 2 HOURS OF OPERATION	Check for loose or missing hardware.
DAILY	Check engine oil level.
DAILY	Check for loose or missing hardware.
AS REQUIRED	Replace/adjust auger drive belt.
	Replace traction drive belt.
	Replace shear bolt.
	Adjust chute controls.
	Adjust spout control lever.
	Clean fuel cap vents.
	Check auger clutch/impeller brake.
	Replace fuel filter, if equipped.
	Check tire pressure.
	Lubricate discharge chute.
	Check traction drive clutch.
	Check speed/shift linkage.
	Check drive chain.
25 HOURS	Lubricate auger drive shaft.
	Check spark plug.
	Change engine oil.
	Check tire pressure.
	Lubricate internal drive.
	Check gearbox lubricant.
	Lubricate discharge chute.
	Adjust auger drive belt tension.
100 HOURS OR YEARLY	Check/clean engine cooling fins.
	Check tire pressure.
	Lubricate auger drive shaft.
	Check gearbox lubricant.
	Lubricate internal drive.
	Lubricate discharge chute.
	Adjust auger drive belt tension.

Introduction