Introduction
Product Identification
Safety
Preparing Vehicle
Installing
Removing
Operating
Replacement Parts
Service
Storage
John Deere Quality Statement
CopyrightŠ Deere & Company
Operating
Speed Selection
c CAUTION: Avoid injury! To avoid injury, change POWER FLOW speeds ONLY when tractor engine and PTO are OFF.
|
The blower for the POWER FLOW has two speeds. Speeds are adjusted by putting the POWER FLOW belt on the upper or lower sheave of the double sheave.
ˇ UPPER (Small) Sheave for SLOW blower speed.
ˇ LOWER (Large) Sheave for FAST blower speed.
Tension Latch Lever
Lever on POWER FLOW is used to unlatch POWER FLOW and loosen or tighten belt tension.
A - Belt Tension Position - Operating position.
B - Release Belt Tension Position - Change speeds or remove belt.
C - Release Blower Latch - Push lever IN to unlatch blower from deck.