John Deere Active Implement Guidance
Copyright 2015 © Deere & Company. THIS DATA IS THE PROPERTY OF DEERE & COMPANY. ALL USE AND/OR REPRODUCTION NOT SPECIFICALLY AUTHORIZED BY DEERE & COMPANY IS PROHIBITED.
All information, illustrations and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice.
Foreword
John Deere Technical Information Bookstore
Section 05 - Safety
Recognize Safety Information
Understand Signal Words
Follow Safety Instructions
Practice Safe Maintenance
Use Steps and Handholds Correctly
Handle Electronic Components and Brackets Safely
Use Electronic Display Properly
Operate Implement Automation Systems Safely
Avoid High-Pressure Fluids
Section 10 - Introduction
Theory of Operation
Active Implement Guidance Requirements
Activate Active Implement Guidance
Machine Compatibility
Replace Erasable Programmable Read Only Memory (EPROM)
Using Active Implement Guidance with iGrade™
Section 15 - Softkey Legend
Application Controller 1100—Setup Softkey
Application Controller 1100—Main Softkey
GreenStar™—Guidance Softkey
StarFire™ 3000—StarFire™ Softkey
StarFire™ 3000—RTK Softkey
StarFire™ 3000—Satellite Softkey
StarFire™ 3000—Diagnostics Softkey
Section 20 - System Components
Monitor and Control System
StarFire™ Receiver
GreenStar™ Display
Wheel Angle Sensor
Application Controller
Counterbalance Valve
External Valve
Active Implement Guidance Height Switch
Section 25 - Configuring Active Implement Guidance
Machine and Implement Setup
Connect Implement
Configure StarFire™ Receiver
Assign Selective Control Valve (SCV)
Implement Receiver Lateral Offset
Implement Receiver Fore/Aft Offset
Set Up Terrain Compensation Module (TCM)
Optimize Terrain Compensation Module (TCM)
Calibrate Terrain Compensation Module (TCM)
Verify Hydraulic Flow Routing and Wheel Angle Sensor Position
(Implement Steering Only)
Calibrate Implement Steering (Implement Steering Only)
Adjust Selective Control Valve (SCV)
Adjust Counterbalance Valve
Set Up Hydraulic Control—Selective Control Valve (SCV)
Set Up Hydraulic Control — External Valve
Section 30 - Operating Active Implement Guidance
Basic Operation of Active Implement Guidance System
Active Implement Guidance Operation
Select Mode for Engagement
Select Optional Guidance Features
Engage Active Implement Guidance
Adjust Sensitivity Settings
Disable Active Implement Guidance
Section 35 - Disconnecting Active Implement Guidance
Disconnecting the Active Implement Guidance System
Section 40 - Third-party Installation
Low Side Driver
Section 45 - Troubleshooting
Satellite Information
Reset Application Controller 1100 Settings
Active Implement Guidance System
Machine
External Valve
Implement Performance
Receiver
Section 50 - Maintenance
Preseason Checklist
Daily Checklist
Postseason Checklist
Section 55 - Service
Active Implement Guidance System
Machine
Section 60 - Specifications
EC Declaration of Conformity
Identify Date Code
Customs Union–EAC
Section SERVLIT - John Deere Service Literature Available
Technical Information
Section IBC - John Deere Service Keeps You on The Job
John Deere Is At Your Service