OMM134889

Issue K7

47-Inch Snowblower

54-Inch Front Blade

51-Inch Rotary Broom

For 4100 Compact Utility Tractor's

Introduction

Safety Signs

Installing

Removing

Park Vehicle Safely

Avoid High Pressure Fluids

Removing Snowblower

Removing Broom

Removing Blade

Operating

Replacement Parts

Service Machine Safely

Service

Troubleshooting

Assembly

Storing Machine

Specifications

John Deere Service Literature

John Deere Quality

Copyright© Deere & Company

REMOVING

Park Vehicle Safely

· Stop vehicle on a level surface, not on a slope.

· Disengage PTO.

· Install storage stands DOWNWARD to support broom.

· Lower broom to ground.

· STOP the engine.

· Engage the park brake.

· Remove the key.

· Before you leave the operator's seat, wait for engine and all moving parts to STOP.

Avoid High Pressure Fluids

· Escaping fluid under pressure can penetrate the skin causing serious injury. Avoid the hazard by relieving pressure before disconnecting hydraulic or other lines. Tighten all connections before applying pressure.

· Search for leaks with a piece of cardboard. Protect hands and body from high pressure fluids.

· If an accident occurs, see a doctor immediately. Any fluid injected into the skin must be surgically removed within a few hours or gangrene may result. Doctors unfamiliar with this type of injury should reference a knowledgeable medical source. Such information is available from Deere & Company Medical Department in Moline, Illinois, U.S.A.

Removing Snowblower

c CAUTION: Avoid injury! Escaping fluid under pressure can penetrate the skin causing serious injury. ·Avoid the hazard by relieving pressure before disconnecting hydraulic lines. ·MAKE SURE to tighten ALL connections before applying pressure.

1. STOP engine.

2. Disengage the PTO.

3. Remove the key.

4. LOCK the park brake.

5. Before you leave the operator's seat, wait for engine and all moving parts to stop.

6. Lower snowblower to the ground.

7. Remove all pressure from hydraulic lines by moving hydraulic control levers back and forth.

M47451

8. Disconnect snowblower hydraulic hoses (A) and put dust plug (B) on end of couplers.

M93535

9. Remove hoses from ring (C) on side of tractor.

10. Disconnect dust plugs (E) from hoses (F) for "Angling Kit" and connect hoses to tractor. (See decal on tractor platform for reference.)

M93532

11. Disconnect driveline (G) from tractor.

M93523

12. Put driveline on PTO rod support (I). (Make sure support is on the inside of the left-hand side of driveshaft shield.)

M55256

13. Put lever (L) in the UNLATCHED position shown.

14. Lower hitch.

15. Slowly back tractor away from snowblower.

c CAUTION: Avoid injury! To help prevent injury: When the snowblower is removed, you MUST also remove any weights that were added to the tractor.

16. Remove any weights that were installed when preparing the tractor. (See Preparing the Vehicle section.)

Removing Broom

1. Park tractor on hard, level surface.

M73724

2. Install stands (A) in the DOWN position.

3. Lower broom onto wheels and stands.

M55398

4. Pull collar (C) on PTO shaft.

5. Remove end of PTO shaft from tractor drive shaft.

6. Install wire support (D) to hold PTO shaft.

7. Pull out and turn J-pins (B) to lock.

8. Lower hitch so J-pin slot is below J-pins.

9. Back tractor away.

Removing Blade

M78431

1. Put L-pins (A) in the LOCKED position.

2. With front hitch lowered back tractor /front mower from front blade.