Lights do not work

Loose or defective bulb.

ON/OFF switch connection loose.

ON/OFF switch defective. (See a John Deere dealer)

Loose or corroded battery connections.

Blown fuse in vehicle charger receptacle. (See a John Deere dealer)

Motor will not run

Battery set power completely depleted.

Shift lever in NEUTRAL "N" position.

Park brake/emergency stop lever not fully unlocked.

Service/drive switch not in the RUN position.

Key switch not in the ON ("1") position.

Loose or corroded battery connections.

Charger DC outlet plug connected to vehicle.

Defective motor controller, or other electrical condition. (See a John Deere dealer)

Batteries low in capacity (Shorter than expected run time)

Batteries not fully charged. Charge battery set.

Dead cell in battery-check specific gravity.

Old battery(s)-check specific gravity.

Loose or corroded battery connections.

Electrolyte levels-correct if necessary.

Load test needed. (See a John Deere dealer)

Batteries will not charge

Frayed or damaged power cords.

AC and DC power cords properly connected.

Electrical supply circuit breaker.

Blown fuse in vehicle charger receptacle. (See a John Deere dealer)

Defective Charger. (See a John Deere dealer)