GS2 Rate Controller

All information, illustrations and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice.

Foreword

Section : 05 - Safety

Recognize Safety Information
Understand Signal Words
Follow Safety Instructions
Prepare for Emergencies
Operate Safely
Handle Agricultural Chemicals Safely
Working With Anhydrous Ammonia
Anhydrous Ammonia Safety
Ammonia Facts
Emergency Procedure For Anhydrous Ammonia
Handle Chemical Products Safely
Wear Protective Clothing
Practice Safe Maintenance
Dispose of Waste Properly

Section : 10 - Safety Signs

Unexpected NH3 Flow Detected
Unexpected NH3 Flow Detected
Unexpected Chemical Flow Detected
NH3 Energize System Test
Configuration Tests

Section : 15 - Safety Features

Safety Features
Implement Height Switch

Section : 20 - Operating GS2 Rate Controller

System Overview
GS2 Rate Controller
Rate Controller Main Page
Main Screen Indications
Implement Section and Rate Control
Implement Section States
Refilling Tank
Main Page Display

Section : 25 - Implement Setup

Implement Setup
Implement Setup
Implement Selection
Setup Implement Sections

Section : 30 - Sprayer System Setup

System Setup
System Setup
Initial Settings
Control Valve Calibration Table
Initial Settings

Section : 35 - NH3 Tool System Setup

System Setup
System Setup
Initial Settings
Control Valve Calibration Table
Initial Settings

Section : 40 - Liquid Fertilizer System Setup

System Setup
System Setup
Initial Settings
Control Valve Calibration Table
Initial Settings

Section : 45 - Alarms Setup

Alarms Setup
Alarm Settings

Section : 50 - Rate Setup

Rate Setup
Spray Rates
NH3 Rates

Section : 55 - Controller Diagnostics

Diagnostic Page
Readings
Rate Controller Readings
Rate Controller Tests
Configuration Test
Calibration Test
Nozzle Flow Check Test
Rinse Cycle
Energize System

Section : 60 - Reports and Totals

Reports and Totals

Section : 65 - Switch Box Controller

Switch Box

Section : 70 - Limp Home Mode

Limp Home

Section : 75 - System Speed Signal

System Speed Signal

Section : 80 - Pressure Transducer

Pressure Transducer (Optional)

Section : 85 - Receiver Offset Setup

Receiver Offset
IMPLEMENT 1 tab

Section : 90 - Appendix

Adapter Harness (31-Pin to 16-Pin) Table (RAVEN Connectors)
Main Harness (37-Pin Connector) Table

Section : SERVLIT - John Deere Service Literature Available

Technical Information

Section : IBC - John Deere Service Keeps You on The Job

John Deere Is At Your Service