GREENSTAR Forage Harvester Yield Monitor System
Copyright 2002 (c) Deere & Company. THIS DATA IS THE PROPERTY OF DEERE & COMPANY. ALL USE AND/OR REPRODUCTION NOT SPECIFICALLY AUTHORIZED BY DEERE & COMPANY IS PROHIBITED.
All information, illustrations and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice.
Foreword
Predelivery Inspection
Before You Start
Section : 05 - Safety
Recognize Safety Information
Understand Signal Words
Follow Safety Instructions
Keep Riders Off the Machine
Prepare for Emergencies
Practice Safe Maintenance
Avoid Heating Near Pressurized Fluid Lines
Keep Hands Away From Knives
Stay Clear of Harvesting Units
Avoid Contact With Moving Parts
Avoid High-Pressure Fluids
Remove Paint Before Welding or Heating
Dispose of Waste Properly
Section : 10 - Component Location
GREENSTAR Display
Mass-Flow Sensor
Feed Roll Speed Sensor
Job Computer
Integrated Printer (Option)
Section : 15 - Operating GreenStar Yield Monitor
Display and Keypad Function Identification (Factory Settings)
General Information
Yield Monitor Run Functions (Factory Settings)
Run-Page 1
Run-Page 2
Yield Monitor Setup Functions
Setup
Setup-Reprogram (With Printer Option Only)
Setup-SPFH Yield
Setup-Machine Data
Setup-Operation Data
Setup-Mass-Flow Cal.
Setup-Moisture Cal.
Setup-Alarms
Setup-Run Pages
Setup-Perf Monitor
Setup-Display-Page 1
Setup-Display-Page 2
Setup-Run Page Layout
Setup-Tracking
Yield Monitor Info Functions
Info (Without Printer Option)
Info (With Printer Option)
Info-Printer
Info-Reprogram
Info-SPFH Yield
Info-Field Totals (Without Printer Option)
Info-Field Totals (With Printer Option)
Info-Load Totals (Without Printer Option)
Info-Load Totals (With Printer Option)
Info-Crop Totals (Without Printer Option)
Info-Crop Totals (With Printer Option)
Info-SPFH Diagnostics
Info-Moisture Sensor
Info-Mass-Flow Sensor
Info-Recent Problems
Info-Display
Section : 20 - GreenStar Yield Calibration
General Information
Yield Calibration
Moisture Correction
Section : 25 - Troubleshooting
Warning Screens
Job Computer Diagnostic Trouble Code List
Display Diagnostic Trouble Code List
Job Computer
Mass-Flow Sensor
Display
Section : 30 - Service and Maintenance
Adjusting Feed Roll Speed Sensor
Checking Feed Roll Stop Plates-Every 50 Hours
Changing Printer Paper Roll-As Required
Changing Printer Ink Ribbon-As Required
Section : 35 - Specifications
Metric Bolt and Cap Screw Torque Values
Declaration of Conformity
Safety Note Regarding the Subsequent Installation of Electrical and Electronic Appliances and/or Components
Section : 40 - Serial Numbers
Identification Labels
GreenStar Display Serial Number
Mass-Flow Sensor Serial Number
Job Computer Serial Number
Printer Serial Number
Section : IBC - John Deere Service Keeps You On The Job
John Deere Parts
The Right Tools
Well-Trained Technicians
Prompt Service