5038D, 5042D, 5045D and 5050D Tractors
Copyright 2013 © Deere & Company. THIS DATA IS THE PROPERTY OF DEERE & COMPANY. ALL USE AND/OR REPRODUCTION NOT SPECIFICALLY AUTHORIZED BY DEERE & COMPANY IS PROHIBITED.
All information, illustrations and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice.
Foreword
Section 05 - Safety
Recognize Safety Information
Understand Signal Words
Follow Safety Instructions
Prepare for Emergencies
Wear Protective Clothing
Protect Against Noise
Handle Fuel Safely—Avoid Fires
Handle Starting Fluid Safely
Fire Prevention
In Case of Fire
Keep ROPS Installed Properly
Use Foldable ROPS and Seat Belt Properly
Stay Clear of Rotating Drivelines
Use Steps and Handholds Correctly
Read Operator Manuals for ISOBUS Implements
Use Seat Belt Properly
Operating the Tractor Safely
Avoid Backover Accidents
Limited Use in Forestry Operation
Operating the Loader Tractor Safely
Keep Riders Off Machine
Instructional Seat
Use Safety Lights and Devices
Transport Towed Equipment at Safe Speeds
Use Caution On Slopes and Uneven Terrain
Freeing a Mired Machine
Avoid Contact with Agricultural Chemicals
Handle Agricultural Chemicals Safely
Handling Batteries Safely
Avoid Heating Near Pressurized Fluid Lines
Remove Paint Before Welding or Heating
Handle Electronic Components and Brackets Safely
Practice Safe Maintenance
Avoid Hot Exhaust
Clean Exhaust Filter Safely
Work In Ventilated Area
Support Machine Properly
Prevent Machine Runaway
Park Machine Safely
Transport Tractor Safely
Service Cooling System Safely
Service Accumulator Systems Safely
Service Tires Safely
Service Front-Wheel Drive Tractor Safely
Tightening Wheel Retaining Bolts/Nuts
Avoid High-Pressure Fluids
Do Not Open High-Pressure Fuel System
Store Attachments Safely
Dispose of Waste Properly
Section 10 - Safety Signs
Pictorial Safety Signs
Operator’s Manual
Riders
Starter
ROPS
Section 15 - Controls and Instruments
Tractor Controls
Instrument Panel
Section 20 - Lights
Light Switch Positions
Use Headlights
Use High Beam Indicator
Use Tail Lights
Use Turn Signals
Use Hazard Lights
Use Flood Lamp
Seven-Terminal Outlet
Section 25 - Operator's Platform
Select Seat Position
Adjust Ride Comfort
Section 35 - Break-In Period
Observe Engine Operation Closely
Break-In Service
Section 40 - Prestarting Checks
Service Daily Before Start-Up
Section 45 - Operating the Engine
Before Starting the Engine
Start the Engine
Check Instruments After Starting
Oil Pressure Indicator
Charge System Indicator
Air Restriction Sensor
Coolant Temperature Gauge
Watch Fuel Level
Change Engine Speeds
Warm Up the Engine
Restart Stalled Engine
Avoid Idling the Engine
Observe Engine Work and Idle Speeds
Working With Speed/Hour Meter
Stop the Engine
Use Booster Battery
Section 50 - Driving the Tractor
Reduce Fuel Consumption
Operator Training Required
Driving on Public Roads
Operate Transmission
Shifting Transmission
Select a Gear
Use Brakes
Use Differential Lock
Operating The Mechanical Front Wheel Drive
Stopping Tractor
Section 55 - Rockshaft and 3-Point Hitch
Match Tractor Power to Implement
3-Point Hitch Components
Rockshaft Control Levers
Set Position Control Lever Stop
Use Rockshaft Position Control
Use Draft Control
Adjust Rockshaft Rate-of-Drop/ Implement Lock
Attach Tipping Trailer
Prepare Implement
Position Center Link
Attach Implements to 3-Point Hitch
Adjust Hitch Side Sway
Level the Hitch
Adjust Lateral Float
Adjust Rockshaft Control Lever Friction - MITA Rockshaft (If
Equipped)
Adjust Rockshaft Control Lever Friction- JD Rockshaft
Warm Hydraulic System Oil
Operating Quick Raise & Lower System
Section 65 - Drawbar and PTO
Observe Drawbar Load Limitations
Stay Clear of Rotating Drivelines
Attach PTO-Driven Implement
Operate Tractor PTO
PTO operation indicator
Adjust PTO Clutch Operating Rod
Section 70 - Ballast
Plan for Maximum Productivity
Select Ballast Carefully
Match Ballast to Load Work
Check for Correct Ballast
Measure Wheel Slip—Manually
Ballast Limitations
Ballast Front End for Transport
Ballast Tractor
Ballast MFWD Equipped Tractors
Determine Maximum Rear Ballast
Determine Maximum Front Ballast
Use Cast Iron Weights
Install Rear Cast Iron Weights
Use Liquid Weight
Use Implement Codes
Section 75 - Wheels, Tires and Treads
Service Tires Safely
Check Implement-to-Tire Clearance
Check Tire Inflation Pressure
Tire Inflation Pressure Chart
Select Front Tire Rolling Direction
Tighten Wheel/Axle Hardware Correctly
Tighten Bolts— Front Axle
Tighten Bolt Adjustable Front Axle––If Equipped
Tighten Bolts—Rear Axle (M-20 Stud)
Observe Rear Wheel Tread Width Limitations
Tread Settings—Multi-Position Rear Wheels
Tread Settings—Adjustable Front Axle––If Equipped
Adjust Front Axle Tread Width
Check Toe-In
Adjust Toe-In
Check Toe-in (MFWD Tractor)
Adjust Toe-in (MFWD Tractor)
Adjust Toe-In - Adjustable Front Axle––IF Equipped
Use Correct Tire Combinations
Tire Compatibility Chart
Section 80 - Transporting
Use Safety Lights and Devices
Driving Tractor on Roads
Transport on Carrier
Tow Tractor
Section 85 - Fuels, Lubricants and Coolant
Handle Fuel Safely—Avoid Fires
Handle Fluids Safely—Avoid Fires
Fuel Storage
Diesel Fuel
Diesel Fuel Filters
Fill Fuel Tank
Lubricant Storage
Diesel Engine Oil
Use Correct Transmission-Hydraulic Filter Element
Transmission and Hydraulic Oil
Grease
Section 90 - Service and Maintenance
Observe Service Intervals
Break-In Service
Service Intervals
Section 95 - Service—Every 10 Hours
Check Engine Oil Level
Check Coolant Level
Drain Water and Sediment From Fuel Filter
Lubricate as Necessary
Section 100 - Service—Every 50 Hours
Check Transmission-Hydraulic System Oil Level
Check MFWD Axle Oil Level
Clean and Check Battery
Lubricate Front Axle Pivot Pin
Lubricate Steering Spindles
Lubricate Steering Spindles (Adjustable Front Axle—If
Equipped)
Lubricate Clutch Pedal and Brake Pedal
Inspect Tires and Loose Hardwares
Section 110 - Service—Every 250 Hours
Change Engine Oil and Filter
Service Air Cleaner
Replace Fuel Filter Inserts
Inspect and Adjust Alternator/Fan Belt
Lubricate 3-Point Hitch
Check Neutral Start System
Check and Adjust Clutch Pedal Free Play
Check and Adjust Brake Pedal Free Play
Section 112 - Service—Every 500 Hours
Replace Transmission-Hydraulic Filter
Section 115 - Service—Every 600 Hours
Change Oil in MFWD Axle (If Equipped)
Clean Engine Crankcase Vent Tube
Check Hoses and Hose Clamps for Tightness
Lubricate Rear Axle Bearings
Check Engine Idle Speeds
Check Front Axle Pivot Pin
Adjust Engine Valve Clearance
Check Water Separator Trap
Section 120 - Service—Every 1250 Hours
Change Transmission-Hydraulic Oil and Filter
Clean Transmission-Hydraulic Pickup Screen
Section 125 - Service—Annually
Replace Air Cleaner Elements
Section 130 - Service—2 Years/2000 Hours
Flush Cooling System
Section 135 - Service—As Required
Service Air Cleaner
Adjust Throttle Friction
Section 140 - Service
Additional Service Information
Service Tractor Safely
Engine Break-In Oil
Work In Ventilated Area
Use High-Pressure Washers
Raise Hood
Air Intake System Components
Service Air Cleaner at Regular Intervals
Check Air Intake System
Remove Primary Air Cleaner Element
Clean Primary Element
Wash Primary Element
Inspect Element
Store Element
Replace Alternator/Fan Belt
Fuel System Components
Do Not Modify Fuel System
Bleed Fuel System
Bleed Fuel System At Fuel Injection Nozzles
Engine Cooling System
Clean Grille, Screens and Radiator
Prevent Battery Explosions
Observe Electrical Service Precautions
Battery Access
Remove Battery
Check Battery Condition
Service Battery
Charge Battery
Battery Replacement Specifications
Connect Starter Wiring
Connect Alternator Wiring
Locate Fusible Link
Locate Fuses
Fuse Size and Function
Aim Headlights
Adjust Headlights
Replace Headlight Bulb
Replace Tail Light and Warning Light Bulbs
Replace Flood Lamp Bulb
Check Tires
Section 145 - Troubleshooting
Engine Troubleshooting
Transmission Troubleshooting
Hydraulic System Troubleshooting
Brakes Troubleshooting
Rockshaft and 3-Point Hitch Troubleshooting
Electrical System Troubleshooting
Section 150 - Tractor Storage
Tractor Storage
Remove Tractor From Storage
Section 155 - Specifications
John Deere 5038D Tractor
John Deere 5042D Tractor
John Deere 5045D Tractor
John Deere 5045D Tractor
John Deere 5047D Tractor
John Deere 5050D Tractor
Ground Speeds
Metric Bolt and Screw Torque Values
Unified Inch Bolt and Screw Torque Values
Section 160 - Identification Numbers
Identification Plates
Record Tractor Serial (Chassis) Number
Record Front Axle Serial Number
Record Engine Serial Number
Record Transmission Serial Number
Section 165 - Lubrication Maintenance Record Charts
50, 250 Hour Service Chart
500,600 Hour Service Chart
1250 Hour Service Chart
Annual Service Chart
2000 Hour Service Chart
As Required Service Chart
Section 170 - John Deere Service
John Deere Parts
The Right Tools
Well Trained Technician
Prompt Service