5310, 5410 and 5510 Tractors
Copyright 2001 (c) Deere & Company. THIS DATA IS THE PROPERTY OF DEERE & COMPANY. ALL USE AND/OR REPRODUCTION NOT SPECIFICALLY AUTHORIZED BY DEERE & COMPANY IS PROHIBITED.
All information, illustrations and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice.
Section : 00 - Identification Views
5010 Series
5010 Series HighCrop Version
Section : 05 - Safety
Recognize Safety Information
Understand Signal Words
Follow Safety Instructions
Prevent Machine Runaway
Use Seat Belt Properly
Work In Ventilated Area
Driving the Tractor Safely
Operating the Tractor Safely
Keep Riders Off Machine
Parking and Leaving the Tractor
Handle Fuel Safely-Avoid Fires
Prepare for Emergencies
Wear Protective Clothing
Avoid Contact with Pesticides
Stay Clear of Rotating Drivelines
Use Safety Lights and Devices
Safely Transporting the Tractor
Tow Loads Safely
Freeing a Mired Machine
Practice Safe Maintenance
Remove Paint Before Welding or Heating
Avoid Heating Near Pressurized Fluid Lines
Avoid High-Pressure Fluids
Store Attachments Safely
Service Cooling System Safely
Retighten Wheel Nuts
Prevent Acid Burns
Support Machine Properly
Service Front Wheel Drive Tractor Safely
Service Tires Safely
Dispose of Waste Properly
Section : 10 - Safety Decals
Pictorial Safety Signs
Operator's Manual
Riders
Section : 15 - Controls and Instruments
Vehicle Controls
PTO Reducing Gear
Instruments and Indicator Lights
Section : 20 - Lights
Light and Horn Switch Positions
Full Beam Indicator Light
Tail Lights
Rear Work Light
Adjusting Rear Work Light
Hazard Warning Light Switch
Turn Signal Light
Seven-Terminal Trailer Socket
Section : 25 - Operator's Station and Cab
Roll-Over Protective Structure
Clean Vehicle of Hazardous Pesticides
Avoid Contact with Pesticides
Operater's Platform (Open Station)
Seat Adjustment
Operator's Cab Switches
Dome and Console Lights
Beacon Light
Wiper and Washer System
Fan, Heater and Air Conditioning System Controls
Sun Visor
Tool Box
Section : 30 - Break-In Period
After the First 4 and 8 Hours of Operation
After First 100 Hours of Operation
Section : 35 - Prestarting Checks
Prestarting Checks
Check Transmission-/Hydraulic System Oil Level
Section : 40 - Operating the Engine
Before Starting the Engine
Starting the Engine With a Slave Battery
Starting the Engine
Observe Instruments After Starting the Engine
Oil Pressure Indicator
Alternator Indicator Light
Air Cleaner Restriction Indicator Light
Coolant Temperature Gauge
Observe Fuel Level
Changing Engine Speeds
Warming Up the Engine
Restart a Stalled Engine
Avoid Idling the Engine
Observe Engine Work and Idle Speeds
Speed-Hour Meter
Stopping the Engine
Cold Weather Starting Procedure Using Intake Air Heater System
Starting with a Booster Battery
Towing the Tractor
Section : 45 - Operating the Tractor
Reduce Fuel Consumption
Operator Training Required
Driving Tractor on Public Roads
Chock Block
Shifting Transmission
Operating Transmission Control Levers
Selecting a Gear
Travel Speeds, 5310 and 5410 Tractors with 30 km/h (18.5 mph) Transmission
Travel Speeds, 5310 and 5410 Tractors with 40 km/h (25 mph) Transmission
Travel Speeds, 5510 Tractor with 30 km/h (18.5 mph) Transmission
Travel Speeds, 5510 Tractor with 40 km/h (25 mph) Transmission
Travel Speeds, HighCrop Version with 30 km/h (18.5 mph) Transmission
Travel Speeds, HighCrop Version with 30 km/h (18.5 mph) 12/12 Transmission reduced ratio
Using Brakes
Using Differential Lock
Operating Front Wheel Drive
Stopping the Tractor
Hydraulic Trailer Brakes
Section : 50 - Rockshaft and Three-Point Hitch
Match Tractor Power To Implement
Three-Point Hitch Components
Rockshaft Control Levers
Using Rockshaft Position Control
Position Control Lever Stop
Using Draft Control
Flow Control Valve
Adjusting Rockshaft Rate-of-Drop
Converting Category II Hitch to Category I
Positioning Center Link
Attaching Implements to 3-Point Hitch
Quick-Coupling (Hook-Type) Draft Links
Stabilizer Spacer
Leveling the Hitch
Adjusting Rockshaft Control Lever Friction
Warming Hydraulic System Oil
Section : 55 - Power Take-Off
Attaching PTO-Driven Implement
Operating Rear PTO at Correct Speed
Section : 60 - Ballast
Planning for Maximum Productivity
Selecting Ballast
Ballast Limitations
Ballasting Rear Wheels
Measuring Rear Wheel Slip
Front Weights
Installing Front Weights
Ballasting Two Wheel Drive Tractors
Ballasting Front Wheel Drive Tractors
Section : 65 - Wheels, Tires and Treads
Service Tires Safely
Check Implement-to-Tire Clearance
Tighten Wheel Bolts
Observe Rear Wheel Tread Width Limitations
Adjusting Rear Wheel Tread
Adjusting Front Wheel Tread
Front and Rear Wheel Treads for Trelleborg Tires
Adjusting Front Wheel Tread (Tractors without Front Wheel Drive)
Adjust Front Axle Tread Width (Tractors without Front Wheel Drive)
Check Toe-In
Adjust Toe-In
Setting Steering Stops
Direction of Tire Rotation
Tire Combinations
Tire Size Comparison Chart
Tire Pressures
Section : 70 - Additional Equipment
Drawbar
Use Correct Hose Tips
Control Lever and Coupler Identification
Maximum Permissible Oil Withdrawal
Connecting Cylinder Hoses
Connecting Hose Under Pressure
Flow Control Valve
Remote Hydraulic Cylinders
Height Adjustable Trailer Hitches
Pick-Up Hitch
Section : 75 - Transport
Transporting On Public Roads
Transport on Carrier
Towing Loads
Towing Tractor
Section : 80 - Fuel, Lubricants, Hydraulic Oil and Coolant
Fuel
Handling and Storing Diesel Fuel
Diesel Engine Break-In Oil
Diesel Engine Oil
Transmission and Hydraulic Oil
Front Wheel Drive Axle and Rear Drop Axle Oil
Grease
Diesel Engine Coolant
Operating in Warm Temperature Climates
Oil Filters
Lubricant Storage
Mixing of Lubricants
Alternative and Synthetic Lubricants
Section : 85 - Lubrication and Periodic Service
Using High-Pressure Washers
Observe Service Intervals
Use Correct Lubricant
Service Tractor Safely
Opening Hood
Removing Hood
Removing Side Screens
Air Intake System Components
Fuel System Components
Engine Cooling System Components
Flush Cooling System and Check Thermostat
Test Thermostat Opening Temperature
Air Conditioning System
Observe Electrical Service Precautions
Battery
Adjusting Head Lamps
Replace Head Lamp Bulb
Replace Clearance, Stop and Turn Signal Lamp Bulbs
Replace Rear Work Lamp Bulb
Tire Pressures
Daily or Every 10 Hours
Every 50 Hours
After the First 100 Hours
Every 250 Hours
Every 500 Hours
Every 750 Hours
Every 1250 Hours or Every Two Years
Every 1500 Hours
Every 2000 Hours or Every Two Years
Every 3000 Hours
As Required
Section : 90 - Service - Daily or Every 10 Hours
Check Engine Oil Level
Section : 95 - Service - Every 50 Hours
Check Transmission-/Hydraulic System Oil Level
Check Oil Level of Rear Drop Axle (HighCrop Version)
Check Hub Oil Level of Front Wheel Drive Axle
Lubricate Front Axle Pivot Pins
Lubricate Front Axle King Pins
Lubricate Steering Cylinder Pivot Pins (HighCrop Version)
Section : 100 - Service - Every 250 Hours
Check Coolant Level
Change Engine Oil and Filter
Replace Transmission-/Hydraulic Filter
Check Brake System Oil Level
Checking Belt Wear and Tension
Lubricate 3-Point Hitch
Check Neutral Start System
Check Clutch Pedal Free Travel
Lubricate Front Wheel Drive Shaft Joints
Lubricate Center Link Bracket
Lubricate Pick-Up Hitch (If Equipped)
Pick-Up Hitch (If Equipped), Check Torques of Attaching Bolts
Section : 105 - Service - Every 500 Hours
Drain Water and Sediment from Fuel Tank
Replace Fuel Filter
Lubricate Rear Axle Bearings
Check Hoses and Hose Clamps for Tightness
Lubricate Hub Bearings (Tractors without Front Wheel Drive)
Section : 110 - Service - Every 750 Hours
Clean Engine Crankcase Vent Tube
Check Engine Idle Speeds
Change Transmission-/Hydraulic Oil Suction Strainer
Check Front Axle Pivot Pin
Section : 115 - Service - Every 1250 Hours
Change Transmission-/Hydraulic Oil and Filter
Change Rear Drop Axle Oil (HighCrop Version)
Section : 120 - Service - Every 1500 Hours
Change Oil in Front Wheel Drive Axle Housing
Change Brake System Oil
Section : 125 - Service - Every 2000 Hours or 2 Years
Adjust Engine Valve Clearance
Change Coolant
Test Thermostat Opening Temperature
Section : 128 - Service - Every 3000 Hours
Change Coolant
Test Thermostat Opening Temperature
Section : 130 - Service - As Required
Cleaning Radiator Screens and Oil Cooler Screens
Cleaning Air Conditioning System Condenser (If Equipped)
Adjusting PTO Clutch Operating Rod
Inspect All Tires
Adjust Throttle Friction
Service Air Cleaner at Regular Intervals
Removing Primary Air Cleaner Element
Cleaning Primary Element
Inspecting Element
Storing Element
Cleaning Cab Air Filter
Checking Belt Wear and Tension
Bleeding Fuel System
Fuses
Digital Display - Program Change (*if equipped)
Section : 135 - Troubleshooting
Engine Troubleshooting
Transmission Troubleshooting
Brakes Troubleshooting
Rockshaft and Quick-Coupler 3-Point Hitch Troubleshooting
Remote Hydraulic Cylinders Troubleshooting
Electrical System Troubleshooting
Heater and A/C System Troubleshooting (Cab)
Wipers, Work Lights and Dome Light (Cab) Troubleshooting
Section : 145 - Storage
Storing Tractor
Removing Tractor from Storage
Section : 150 - Specifications
Engine
Transmission
Hydraulic System
Electrical System
Capacities
Sound Level
Weights
Load Capacity Of Tires
Tire Size Comparison Chart
Fuel System
Brakes
Three-Point Hitch
Safety Note Regarding the Subsequent Installation of Electrical and Electronic Appliances and/or Components
Declaration of Conformity
Section : 155 - Serial Numbers
Identification Plates
Product Identification Number
Engine Serial Number
Transmission Serial Number
Record Front Wheel Drive Serial Number
Record Front Axle (2WD) Serial Number
Section : IBC - John Deere Service Keeps You On the Job
John Deere Parts
The Right Tools
Well-Trained Technicians
Prompt Service